Plastic Molds Manufacturer
& Plastic Molded Parts Company

About injection Molding

plastic-molding
During the plastic molding process a solid thermoplastic material is heated to its melting point and then injected (metered under high pressure) into the mold cavity. After a cooling period the plastic becomes rigid enough and the mold opens and the part is ejected.
 
The quality of an injection molded part depends on several variables some of which are listed below:
 
Quality of the injection mold
 
Plastic molding machine cycle repeatability
 
Plastic molding machine controls
 
Process stability
 
Consistency of the auxiliary equipment controls
 
Machine operator skills
 
Proper handling and storage of raw materials
 
Quality of raw materials
 
Avoidance of contamination of raw materials
 
Effective Quality assurance procedure
 
A good quality mold, manufactured to the industry standards by qualified toolmakers, is the basis of a good molded part.
 
The second most important requirement is a plastic molding machine with good repeatability. TO-Molding uses only closed loop CNC plastic molding machines to guarantee the maximum process control and reliability. We regularly perform maintenance on our machines as per manufacturer’s recommendations and keep records of it.
 
Process information per each part is recorded on the machine's memory and recalled every time the machine is set up for a new production run. Backup copies of the process set up for each part and per each machine are saved on portable memory devices and on hard copies. Once the process is established for a part on a certain machine, we can repeat it for every production run with small adjustments to compensate for variances between different lots of raw materials.
 
The type and quality of the auxiliary equipment used to support the plastic molding operations is also very important. We use only descant dryers with dew point indicators to ensure the proper conditioning of hydroscopic engineering resins. Our die heaters and temperature controllers are regularly maintained and inspected for proper functioning. Preventive maintenance records are kept for each manufacturing machine and all auxiliary equipment. All our conveyors are regularly cleaned and inspected for proper functioning too.
 
TO-Molding's employees are what differentiate us from the competition. Our skilled process technicians set up personnel and operators know how to minimize rejects at start up and during production by properly checking the machine parameters and performing the regular quality inspections. Our plastic molding managers supervise the production floor and have more than 30 years’ experience processing plastic molding. Our process technicians and managers have been formally schooled in molding commodity and high tech engineering resins and their processing requirements. Our engineers total over 30 years of hands on plastic molding experience and design assistance. We provide in house training and send our technicians and engineers to outside classes for continuous education.
 
Proper management of raw materials is important to avoid material contamination that could result in part failure during service or rejects during production. Incoming raw materials are inspected, identified and labeled by lot number and type at the time of receiving and stored in our climate controlled warehouse. A material trace number is assigned to each raw material shipment which follows the raw material through the production process. A computerized system keeps track of the raw material location and available quantity. Every container is kept sealed at all time to avoid contamination.
 
Each granulator, machine hopper, and container that is used for production is labeled with the resin in use. At the end of every production batch they are properly cleaned and labeled as ready.
 
We maintain a clean molding facility because we believe good housekeeping is the basis to efficient manufacturing of quality products. We are proud of the place we work in.
 
We have full product traceability. Production records include raw materials trace numbers, machines used and the production operator for each production run. The last shot of each production lot is kept and stored with our quality records for at least 5 years.


Tags: Plastic Molded Parts China | China Plastic Molded Parts Company